Hello.
Watch the video 15 seconds to understand how the application works.
How
can you find/trace the wire in the wall? Here is a way.The application can determine the presence of an alternating current (50 Hz, not voltage!) In the unpaired, single wire for urban or industrial network. The scheme is shown at the top.
Current will be
well-defined under a load of> 0.6 killo watts.
Using mentioned above wiring circuit, wire layout can be determined in the wall.
No matter, is the wire
zero or phase - the main thing that the current should to flow through
one..
The current may be less, but it is better if> 3A.
If one of cords has rupture in wall you always have one of them to pass through/energize it the current.
.................................................. .................
It is enough to see the 14 second video.
.................................................. .............
The application can scan the metal objects only if you use them as a ground for alternating current (50 Hz).
In double wiring , both wire current flow against each other. So standing wave can not be identified.
ATTENTION!
1. Be careful when handling electricity.
2. Not all phones have a magnetic sensor with sufficient frequency measurements.
I've used Sa ms ung S4.
Thank you.
A improvment for devices with
poor activity
magnet sensors.
9Apps 4.9
